cindy@huazhengcnc.com    +8613612857213
Cont

Imate vprašanja?

+8613612857213

Jan 06, 2022

Vrste aluminijevih zlitin za tlačno litje

Al-Mg zlitina

Značilnosti delovanja Al-Mg aluminijeve zlitine so: dobre mehanske lastnosti pri sobni temperaturi; močna odpornost proti koroziji; slabe lastnosti ulivanja, velika nihanja mehanskih lastnosti in učinki debeline stene; dolgotrajna{1}}uporaba, plastičnost zlitine zaradi padca staranja in celo razpoke v tlačnih ulitkih; večja je tudi nagnjenost k razpokanju zaradi napetostne korozije pri tlačnih ulitkih. Slabosti zlitine Al-Mg so delno izravnale njene prednosti, zaradi česar je omejena pri uporabi.

Al-Zn zlitina

Al-Ulitki iz aluminijeve zlitine lahko po naravnem staranju pridobijo višje mehanske lastnosti. Ko je masni delež cinka večji od 10 odstotkov, se moč bistveno izboljša. Pomanjkljivost te zlitine je slaba odpornost proti koroziji, nagnjenost k koroziji zaradi napetosti in enostavno vroče razpoke med tlačnim litjem. Pogosto uporabljena zlitina Y401 ima dobro pretočnost in jo je enostavno zapolniti. Pomanjkljivost je, da ima veliko nagnjenost k tvorbi por, in ko je vsebnost silicija in železa nizka, se zlahka vroče razpoka.

Al-Si zlitina

Because Al-Si aluminum alloy has the characteristics of small crystallization temperature interval, large solidification latent heat of silicon phase in the alloy, large specific heat capacity, and relatively small linear shrinkage coefficient, its casting performance is generally better than other aluminum alloys. Its filling ability is also good, and the tendency of thermal cracking and shrinkage is relatively small. The Al-Si eutectic contains the least amount of brittle phase (silicon phase), and its mass fraction is only about 10 percent , so its plasticity is better than that of other aluminum alloy eutectic, and the remaining brittle phase can be further treated by modification. Improve plasticity. The test also shows that the Al-Si eutectic still maintains good plasticity at the temperature near its freezing point, which is not found in other aluminum alloys. There is often a considerable amount of eutectic in the cast alloy structure to ensure its good casting performance; the increase in the number of eutectic will make the alloy brittle and reduce the mechanical properties, there is a certain contradiction between the two. However, due to the good plasticity of Al-Si eutectic, it can better take into account the requirements of both mechanical properties and casting properties, so Al-Si alloy is currently the most widely used die-casting aluminum alloy. 


Pošlji povpraševanje